HANGZHOU CHUNLAI TECHNOLOGY CO., LTD.
TY_ENS
Steelmaking(wet dedusting) Measuring Points and Solutions

Steelmaking(wet dedusting) Measuring Points and Solutions

The steelmaking process is a big consumer of energy. Converter steelmaking will produce a lot of coal gas which contains 60%-70% CO. It is very important to recycle coal gas in the steelmaking process. A method for purifying and recycling coal gas is wet dedusting. The limitation of this method will leave high dust content in the coal gas after processing. In order to make use of this gas, two dust remover needed to be set to remove dust on the back side. Through online monitoring by continuous flue gas analyzer after treatment, the flue gas can be recycled when it meets recycling requirements to reduce energy consumption and recycle development.

Steelmaking(wet dedusting) Measuring Points and Solutions

NO. Measurement
point
Temperature
Pressure Measurement components
Detection purpose
Recommend products*
1 Induced fan up stream/down
stream
Normal
Slight-negative pressure
O2: 0-5%
CO: 0-100%
Recycle the coal gas when purified flue gas
meets recycling condition
LGT-100 Laser Gas Analyzer
2 Second dust remover down
stream
Normal
Slight-positive
pressure
O2: 0-5%
CO: 0-100%
Control Steelmaking,adjust
production device, realize production optimization
LGT-100 Laser Gas Analyzer
3 Gas tank
upstream
Normal
Slight-positive
pressure
O2: 0-5%
CO: 0-100%
Prevent coal gas tank from accident or explosion
LGT-100 Laser Gas Analyzer
4 Gas tank
downstream
Normal
Slight-positive
pressure
O2: 0-5%
CO: 0-100%
Prevent coal gas tank from accident or explosion
LGT-100 Laser Gas Analyzer

Product catalog
Product Inquiry